AC removal & refitting in Al Muntazah

It depends on the condition of the pipes and the layout at the new site. If the pipes are free of oxidation and insulation cracking, and the length fits the new run, they can be reused after inspection. If the new site needs a longer route or the existing pipes show wear, fresh Mueller copper pipe at 99% pure copper is run to suit the new layout. The site survey decides.

Before any connection is opened, the compressor is run to pump the refrigerant charge into the outdoor unit and the service valves are closed on it. If the connections are opened first, the refrigerant escapes into the air and is lost entirely, which is both costly and harmful to the environment. Pumping down first keeps the full charge sealed inside the outdoor unit, ready to use at the new site.

Once the pipes and cable are pulled out, the hole is cleared of insulation remnants and sleeve material, then sealed with a filler suited to the wall type, whether concrete, brick or gypsum board. The aim is a tight closure that stops humid air and insects from entering and leaves the wall surface clean before the site is handed back.

Yes, but moving to a different floor means a completely new pipe route, a different cable length, and possibly a changed drain line fall. The site survey defines the pipe path, the required run length and the outdoor unit position. Mueller copper pipe at 99% pure copper is then laid along a route that accounts for the floor difference, and a vacuum test and pressure test are carried out before the unit is started.

Yes, but a different floor changes the copper run length, the drain route and where the outdoor unit is fixed. At the survey we establish whether extra copper is needed and where the drain can fall correctly, then plan the full route before any removal begins.

Longer line runs can slightly affect cooling efficiency, but we use high-grade copper and thoroughly vacuum the line to maintain good performance even over long distances. Send us a photo of the new location so we can assess it.

Intense heat on the east-facing wall can reduce transport efficiency. We install the line with good thermal insulation and seek shade where possible, which will help maintain performance in hot weather.

Yes, we can coordinate moving several units if different flats need relocation in the same period. Tell us how many units and where they are, and we will provide a work plan.

Yes, we regularly move units between neighbouring villas. We recover the refrigerant from the old unit, transport it safely to the new villa, then install new copper matched to the distance and new location.