AC removal & refitting in Al Ruhaili

It depends on the condition of the pipes and the layout at the new site. If the pipes are free of oxidation and insulation cracking, and the length fits the new run, they can be reused after inspection. If the new site needs a longer route or the existing pipes show wear, fresh Mueller copper pipe at 99% pure copper is run to suit the new layout. The site survey decides.

Before any connection is opened, the compressor is run to pump the refrigerant charge into the outdoor unit and the service valves are closed on it. If the connections are opened first, the refrigerant escapes into the air and is lost entirely, which is both costly and harmful to the environment. Pumping down first keeps the full charge sealed inside the outdoor unit, ready to use at the new site.

Once the pipes and cable are pulled out, the hole is cleared of insulation remnants and sleeve material, then sealed with a filler suited to the wall type, whether concrete, brick or gypsum board. The aim is a tight closure that stops humid air and insects from entering and leaves the wall surface clean before the site is handed back.

Yes, but moving to a different floor means a completely new pipe route, a different cable length, and possibly a changed drain line fall. The site survey defines the pipe path, the required run length and the outdoor unit position. Mueller copper pipe at 99% pure copper is then laid along a route that accounts for the floor difference, and a vacuum test and pressure test are carried out before the unit is started.

Yes, but a different floor changes the copper run length, the drain route and where the outdoor unit is fixed. At the survey we establish whether extra copper is needed and where the drain can fall correctly, then plan the full route before any removal begins.

Yes, we relocate the entire unit including refrigerant recovery and copper removal, then reinstall it at the new site with fresh copper after vacuum testing. We need to know the distance between the outdoor and indoor units at the new villa to determine the copper length required.

We inspect the location first to ensure safe access to the unit, and use proper equipment to remove AC systems from tight corners and high mounting points. If access is very difficult, we inform you before starting.

An AC's performance depends on the unit itself and its capacity, not its location in the district. After moving with fresh copper and full vacuum testing, it performs at its original efficiency, though direct sun exposure on the outdoor unit affects its output anywhere.

You must have a sturdy electrical circuit and proper grounding point near the planned outdoor unit location. If the distance is very large, you may need an electrical extension by a licensed electrician, which is outside our scope, but we inspect the site and advise you on what is needed.