AC removal & refitting in Quwaizah

It depends on the condition of the pipes and the layout at the new site. If the pipes are free of oxidation and insulation cracking, and the length fits the new run, they can be reused after inspection. If the new site needs a longer route or the existing pipes show wear, fresh Mueller copper pipe at 99% pure copper is run to suit the new layout. The site survey decides.

Before any connection is opened, the compressor is run to pump the refrigerant charge into the outdoor unit and the service valves are closed on it. If the connections are opened first, the refrigerant escapes into the air and is lost entirely, which is both costly and harmful to the environment. Pumping down first keeps the full charge sealed inside the outdoor unit, ready to use at the new site.

Once the pipes and cable are pulled out, the hole is cleared of insulation remnants and sleeve material, then sealed with a filler suited to the wall type, whether concrete, brick or gypsum board. The aim is a tight closure that stops humid air and insects from entering and leaves the wall surface clean before the site is handed back.

Yes, but moving to a different floor means a completely new pipe route, a different cable length, and possibly a changed drain line fall. The site survey defines the pipe path, the required run length and the outdoor unit position. Mueller copper pipe at 99% pure copper is then laid along a route that accounts for the floor difference, and a vacuum test and pressure test are carried out before the unit is started.

Yes, but a different floor changes the copper run length, the drain route and where the outdoor unit is fixed. At the survey we establish whether extra copper is needed and where the drain can fall correctly, then plan the full route before any removal begins.

Yes, we relocate the unit from the old villa by fully pumping the refrigerant and safely disconnecting the lines. At the new villa we install new copper lines to the required length and location, and fully test the unit.

Longer distances may have a slight impact, but correctly sized copper lines and good insulation maintain performance. We test pressure and airflow after installation to ensure even cooling.

We choose a spot with shade or cover from direct sun if possible, such as the north side or under an awning, and somewhere easy to access for maintenance.

Before our visit, confirm the electrical circuit at the new location is adequate for the unit, and that condensate drainage is in place or can be easily extended.