AC repair & faults in Al Mawj

The technician measures the capacitor's microfarad value and compares it with the figure printed on the casing. If the reading is low, the capacitor is replaced first and the unit is retested. The compressor is only judged after confirming the surrounding circuit is sound, and this sequence prevents replacing an expensive part without reason.

Cleaning alone is not enough if the drain line does not have the right fall or the drain tray has a small crack. We follow the water path from the tray to the outdoor drain outlet and check the fall at every section. Sometimes the indoor coil freezes and thaws because of poor airflow, which is a different cause and needs a different check.

It depends on the type of sound. A click at start-up is often plastic expanding with heat; a continuous hiss may point to a leak at a joint; a rattling sound usually means something caught in the fan or a fan that needs balancing. The technician describes the cause after listening and checking both units.

There is no fixed rule, but we consider the unit's age, the refrigerant type written on its nameplate and the cost of the repair against the price of a new unit. If faults keep returning or the refrigerant type is hard to source, replacing makes more economic sense. The technician lays the calculation out clearly before any decision is made.

A musty smell usually comes from bacterial growth on the evaporator coil or a stagnant drain tray, which is a cleaning matter. But a burning or hot-plastic smell points to heat in the electrical circuit or a component about to fail, and in that case a fault technician must inspect the unit before it is run again.

Salt and humidity accelerate corrosion of joints and copper wiring, so regular maintenance and early fault diagnosis reduce long-term costs.

We arrange safe access to the balcony with you beforehand and coordinate with building residents if needed to ensure safe movement for our team and equipment.

Rust on the outer casing can affect internal connections over time, causing sudden loss of cooling. A thorough check determines actual damage before replacement.

Yes, salt accelerates corrosion at weak points in copper tubing. Our diagnosis pinpoints the leak location precisely so we fix it at the source, not just add more refrigerant.