HVAC & refrigeration technician in Al Fayhaa

The technician brings pressure gauges to check the refrigeration cycle, electrical meters to test the capacitor, relay and control board, and leak detection and flare joint tools. The exact kit depends on the fault description you give when you book.

Yes. The technician covers both air conditioning and refrigeration, so if you have a faulty AC and a commercial fridge or cold unit at the same location he inspects both in one visit and explains the condition of each separately before any repair begins.

The technician diagnoses the fault first, whether a failing capacitor, a deteriorated flare joint or a blocked drain line, then tells you what he found, what work is needed and which parts must be replaced. No work starts until you have approved what he has explained.

After the inspection the technician names the part needed and explains why. If the part is available on site the repair is done in the same visit. If it has to be sourced first, he agrees a second visit with you. No replacement is started without your knowledge of what will be done.

Yes. A split unit gives direct access to the coil, filter and flare joint. A ducted or cassette unit also needs the plenum, dampers and duct runs checked to confirm air is distributed correctly. The technician decides the inspection method after seeing the unit type and installation at your site.

We inspect each indoor and outdoor unit separately, confirm thermal balance between them and pressure in each, and give you a full report before starting any work.

Yes, we inspect each unit separately and check compressor load and airflow in each, since high pressure in one may affect the other.

High humidity increases load on the compressor and condenser, so we clean the condenser and ducts and check drying efficiency, and advise cleaning every six weeks.

Yes, we service mosques and religious buildings with inspection and maintenance of central and split systems, and provide regular maintenance schedules.