HVAC & refrigeration technician in Al Rawdah

The technician brings pressure gauges to check the refrigeration cycle, electrical meters to test the capacitor, relay and control board, and leak detection and flare joint tools. The exact kit depends on the fault description you give when you book.

Yes. The technician covers both air conditioning and refrigeration, so if you have a faulty AC and a commercial fridge or cold unit at the same location he inspects both in one visit and explains the condition of each separately before any repair begins.

The technician diagnoses the fault first, whether a failing capacitor, a deteriorated flare joint or a blocked drain line, then tells you what he found, what work is needed and which parts must be replaced. No work starts until you have approved what he has explained.

After the inspection the technician names the part needed and explains why. If the part is available on site the repair is done in the same visit. If it has to be sourced first, he agrees a second visit with you. No replacement is started without your knowledge of what will be done.

Yes. A split unit gives direct access to the coil, filter and flare joint. A ducted or cassette unit also needs the plenum, dampers and duct runs checked to confirm air is distributed correctly. The technician decides the inspection method after seeing the unit type and installation at your site.

Corrosion on pipes may cause refrigerant leaks. We inspect pipes carefully and advise replacement if leakage is serious.

Yes, humidity speeds up outdoor unit and pipe corrosion. We advise periodic cleaning and seasonal checks to reduce wear.

We clean condenser coils monthly, inspect pipes and compressor, and check temperatures are appropriate. We visit regularly as needed.

Sudden power cuts can affect the compressor and electronics. We check the electrical circuit and protection before startup.