Freezer and dual-temp rooms
Cold & freezer room installation in Al Yusr
In Al Yusr, north Jeddah, cold and freezer room installation serves small restaurants, boutique hotels and specialist stores needing secure storage for varied food items. We size the room to your daily meal volume or stock and build it with effective insulation and a tight door seal.
- Frost-proof floor
- Auto defrost
- Two-zone layout
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
Who needs a specialist freezer room?
- 1
Stock that needs sub-zero cold
Meat, poultry, fish and ice cream spoil if the temperature rises even briefly above the required level. A freezer room is built to hold that level continuously, not simply to cool.
- 2
One room, two temperature zones
Large restaurants and hotels usually need a chiller section and a freezer section side by side. We build both wings with separate insulation, independent refrigeration units and an insulated inner door, so neither zone affects the other's temperature.
- 3
Expanding an existing facility
If your current cold room no longer holds all your stock, or you need to add a freezer section beside it, we survey the site and propose the most practical way to expand with as little disruption to your operation as possible.
Who it's for
Opening a restaurant that needs a freezer room
We survey your kitchen and build the freezer room with frost-rated insulation panels, an insulated floor and a tight-sealing door.
Ask on WhatsAppNeed a chiller wing and a freezer wing together
We build both wings with separate insulation, independent refrigeration units and an insulated inner door between them.
Ask on WhatsApp
What the installation covers
- Freezer-rated insulation panels
- Insulated floor vapour barrier
- Heated frame tight-sealing door
- Evaporator with electric defrost
- Condensing unit temperature controller
How we work
How we work
- 1
Site survey
We visit the site, learn the stock type and required temperature, measure the available space, and decide the right insulation thickness and refrigeration system from what we find.
- 2
Design and supply
We draw the room layout including pipe and cable routes, then have the panels, doors and equipment ready before installation begins.
- 3
Installation and connection
We fit the panels, insulated floor and door, then run and insulate the copper pipes, vacuum the line and pressure-test it before starting the system. Mueller copper in runs of up to 30 metres without welded joints where the layout calls for it.
- 4
Start-up and handover
We run the system and watch the room reach its target temperature, confirm the defrost cycle works and the door seals properly, then explain the controls to the person responsible for the facility.
Specialist install or an unconsidered one?
| Alrabih | The usual way | |
|---|---|---|
| Floor | Insulated with vapour barrier | Plain floor that cracks |
| Door frame | Heated to prevent seizure | Freezes and warps |
| Evaporator | Scheduled electric defrost | Ice blocks the airflow |
| Insulation | Thickness set at survey | Same thickness for every room |
| Anteroom | Buffer zone reduces air ingress | Direct door into freezer |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Al Yusr is a mixed residential and commercial neighbourhood with small restaurants, modest-sized hotels and specialist shops, where buildings are medium-height with relatively tight rear or under-roof spaces. This means we must design the freezer room carefully to fit the available footprint and run pipes and drainage in ways that suit the existing layout. Coastal humidity and summer heat mean the insulation must be robust and a heated door frame is essential to prevent cold-air leakage.
Al Yusr sits in north Jeddah as a mixed residential and commercial area with medium-height buildings and tight rear spaces behind shopfronts.
Most freezer rooms here are small to medium, 4 to 8 square metres, placed on the ground floor or rear yard of the restaurant or shop.
The AC setup in Al Yusr
- 1
Compact freezer room in the back yard
Small restaurants in Al Yusr often place a 4-to-6 square metre freezer room in the back yard, away from the cooking area and staff zones.
- 2
Freezer room under-shop or on ground level
Some specialist shops use under-shop or ground-level space for the room, reducing its visual impact on the storefront.
- 3
Room with reinforced insulation for coastal humidity
Proximity to the coast means extra insulation and tight seals on walls, floor and door to block moisture infiltration and keep cooling efficient.
Before the visit
Before our visit in Al Yusr
- 1
Measure the available space precisely
Before we visit, measure the length, width and height of the planned room space precisely, and check for any existing water or electrical lines that may need shifting.
- 2
Identify outdoor unit location and pipe routing
Clarify whether the roof or yard is available, and where cooling pipes and the drain line can run without clashing with foot traffic or existing gear.
- 3
Confirm electrical connection adequacy
Check that you have a dedicated breaker with adequate capacity for the unit, and identify the safest connection point near the main electrical panel.
More districts for Cold & freezer room installation
Other services in Al Yusr
FAQ
Questions about Cold & freezer room installation
Why does a freezer room need an insulated floor when a chiller often does not?
At sub-zero temperatures the moisture held in a concrete slab freezes and expands, cracking tiles and lifting bases over time. A chiller room operates above freezing, so ice crystals do not form in the slab. A freezer room therefore requires insulated panels under the floor together with a vapour barrier that blocks rising ground heat and protects the structure over the long term.
What is the difference between electric defrost and other types?
Electric defrost uses heating elements fixed inside the evaporator coil; they warm the coil directly and melt frost build-up. Hot-gas defrost instead redirects warm refrigerant from the compressor back through the same coil. The choice between the two depends on room size, the required number of cycles and the type of goods stored; the site survey determines which method suits each installation.
Can two zones at different temperatures share the same footprint?
Yes. A partition of insulated panels separates the space, with each side using a panel thickness matched to its required temperature differential. Each zone has its own refrigeration unit and a door with a heated frame to prevent condensation. This arrangement is widely used in meat and fish facilities that need a chiller zone for short-term stock and a freezer zone for longer storage. The final design depends on the available floor area and the heat load of each section.
Does the position of the condensing unit affect how the freezer room performs?
Position has a direct effect. The condensing unit needs clean air and adequate flow to reject heat; if it is placed in a confined space or near heat sources the condensing pressure rises and the compressor works harder. In Jeddah, outdoor air also carries salt and dust that accumulate on the condenser coil over time. The site survey identifies the best location and the copper-pipe route, keeping each Mueller copper pipe run within thirty metres without welded joints.
Does the position of the condensing unit affect how the freezer room performs?
Position has a direct effect. The condensing unit needs clean air and adequate flow to reject heat; if it is placed in a confined space or near heat sources the condensing pressure rises and the compressor works harder. In Jeddah, outdoor air also carries salt and dust that accumulate on the condenser coil over time. The site survey identifies the best location and the copper-pipe route, keeping each Mueller copper pipe run within thirty metres without welded joints.
Will a freezer room take up too much of my small restaurant's space?
No, we size the room to your actual available space, and even 4 square metres is enough for a small restaurant or specialist shop, and smart design keeps foot traffic flowing.
How do you fit the outdoor unit in older, narrow buildings?
We mount the unit on the roof or in the yard, sometimes on a supported external wall, and work with the shop or restaurant owner to find the best spot for drainage and airflow.
Does the coastal humidity affect the door seal and insulation?
Yes, high humidity speeds seal wear, so we fit an electrically heated door that prevents frost sticking and thick insulation that maintains cold and dry conditions inside.
Drainage and water, are there issues in older buildings?
We inspect the existing drainage before installation and connect the room's condensate line to the nearest safe outlet, ensuring water does not pool under the floor or affect the foundation.
