Mosque HVAC in Al Mu'ailiyah

At the survey we set diffuser angles, air velocity and duct routing so cold air travels to the last row. After installation we measure the temperature difference between the front and back rows and adjust each diffuser's balance until that difference is as small as the space allows.

Yes. We agree a phased schedule with mosque management in advance and divide the work into sessions between prayers. Before each call to prayer we lift tools, cover any temporary openings and return the hall to a usable state, then resume afterwards.

We fabricate ducts in our own workshop from G90 galvanised sheet, round or rectangular as the design requires. We use Armaflex and Kimmco insulation and Foster sealants to limit heat gain and keep sound transmission through the ductwork as low as possible.

Yes. The controls on Carrier, YORK, General, Midea, Gree and Smart Gold units support scheduled start and stop times. At the survey we confirm the scheduling options for the chosen units and programme the timings at handover, so the hall is already cool when worshippers arrive.

Yes, if the system is designed in zones. We divide the hall into sections, each with its own unit or closable outlets, so you run the front rows alone when few people attend and the whole hall for Friday prayer and occasions, cutting power use without affecting worshippers.

Yes, we calculate ducts and outlets precisely for hall depth and width, ensuring cool air reaches front, back and sides uniformly.

We install smart controls that reduce system speed or shut it down during empty periods, then automatically restart ahead of the next prayer time.

We select units with strong dehumidification capacity and ample cooling power, and perform regular coil and drain maintenance to prevent mould and odours.

We carefully select air speeds and angle outlets to avoid noise, and insulate main ducts to minimise any disturbing sound.