School HVAC in Al Murooj

Noise usually comes from high air velocity or an indoor unit mounted on a shared wall between two classrooms. We select units with low sound ratings, calculate air velocity at each outlet to prevent whistling, and insulate duct runs above the suspended ceiling. The exact unit position and diffuser angle are decided during a site survey of each room.

The prayer room needs wide, quiet air distribution at low level above worshippers, which is quite different from a classroom. Corridors need enough cooling to prevent hot air from flowing into classrooms when doors open. We design each zone on its own air circuit with a separate thermostat; the final layout depends on floor area and ceiling height on site.

In most cases, yes. We check the gap between the ceiling and the slab, and how accessible the ceiling void is, before making any decision. We fabricate round or rectangular ducts in our own workshop to match the building's exact dimensions, and we route them to avoid structural columns and penetrations. Where ceiling space is too tight, cassette or concealed units may be the better fit.

A low-mounted unit in a room full of students is easily damaged: fins get bent, the drain port gets blocked, and the fan grille gets broken. We mount units at heights and positions that keep them clear of students, while still delivering cooled air down to the seated zone. The precise position is set after the team measures ceiling height and seating layout in each room.

Large tasks such as running new ductwork or replacing multiple units are scheduled during the long summer break to avoid any disruption to lessons. Routine maintenance and isolated repairs can be arranged outside school hours or at weekends in coordination with school management. Work inside classrooms during the school day requires a site assessment first to confirm it can be done without causing disruption.

We visit the building and take precise measurements of length, width and height in each section, calculate sun exposure (north, south, east and west-facing facades), determine student and staff numbers, then select cooling units based on these factors.

High ceilings cause chilled air to disperse, so we design distribution vents at calculated heights to reach student level and use speed regulators to reduce excessive air velocity.

We select equipment from trusted brands (Carrier, YORK, General, Midea, Gree, Smart Gold) known for efficient operation in hot climates, and we use insulated ducts that preserve cool air from the unit to the classrooms.

Start maintenance mid-summer break, we clean filters, coils and ducts, test all thermostats and dampers, and confirm all systems are ready at least a week before students return.