Warehouse HVAC in Al Khumrah

It depends on indoor humidity levels and the type of stock stored. In well-ventilated open areas where stock is not sensitive to a small rise in humidity, evaporative cooling can work well. The site survey gives a clear answer before any decision is made.

In a tall bay, cool air settles low and hot air rises, which works in your favour when diffusers are aimed correctly at the working level and the racking. We set diffuser angles and positions during design based on the racking height and the movement aisles.

Cold rooms and freezer rooms run on their own refrigeration systems, which we install as a separate service. What we handle here is the ambient air around those room doors, so warm warehouse air does not rush in when they open, managed by pressure zoning between the two spaces.

Yes, especially ducts that run close to the hot metal roof. Without insulation, cool air gains heat before it reaches the diffusers and loses much of its effect. We insulate with Armaflex or Kimmco materials and seal joints with Foster sealants to stop air leaks.

Yes. In tall racking aisles the airflow path narrows and slows, so we choose directional diffusers that push air along the aisle length rather than spreading it sideways. In open floor areas we use wider-angle diffusers. The angle and position of each diffuser are set at design stage based on the aisle width and racking height.

We use salt-resistant materials in pipes and outdoor units, apply protective coatings to metal parts, and advise regular rinsing of outdoor units with fresh water.

The AC reduces humidity but in high-humidity coastal zones you may need a separate dehumidifier for sensitive storage or staff areas.

We advise monthly inspections and cleaning every two months in summer, and every three months in winter, because salt and moisture clog filters and coils rapidly.

Yes, AC condensate drainage can be affected by rising groundwater during rainfall, so we advise an elevated drain system or emergency pump.