Warehouse HVAC in Al Nada

It depends on indoor humidity levels and the type of stock stored. In well-ventilated open areas where stock is not sensitive to a small rise in humidity, evaporative cooling can work well. The site survey gives a clear answer before any decision is made.

In a tall bay, cool air settles low and hot air rises, which works in your favour when diffusers are aimed correctly at the working level and the racking. We set diffuser angles and positions during design based on the racking height and the movement aisles.

Cold rooms and freezer rooms run on their own refrigeration systems, which we install as a separate service. What we handle here is the ambient air around those room doors, so warm warehouse air does not rush in when they open, managed by pressure zoning between the two spaces.

Yes, especially ducts that run close to the hot metal roof. Without insulation, cool air gains heat before it reaches the diffusers and loses much of its effect. We insulate with Armaflex or Kimmco materials and seal joints with Foster sealants to stop air leaks.

Yes. In tall racking aisles the airflow path narrows and slows, so we choose directional diffusers that push air along the aisle length rather than spreading it sideways. In open floor areas we use wider-angle diffusers. The angle and position of each diffuser are set at design stage based on the aisle width and racking height.

Central zoned cooling reduces the metal roof's direct heat impact. We assess your warehouse size first, then select outdoor units and distribution ducts to match the layout.

Yes, large open areas can have hot spots. We design the air ducts and vents to distribute cooling more evenly and reduce heat pockets.

High humidity in east Jeddah needs a cooling system that removes moisture as well as cools. We choose units with suitable humidity control ratings.

It depends on warehouse size, the number of cooling units and ducts. We assess total electrical load on site and take accurate measurements before installation.