Warehouse HVAC in Kilo 14

It depends on indoor humidity levels and the type of stock stored. In well-ventilated open areas where stock is not sensitive to a small rise in humidity, evaporative cooling can work well. The site survey gives a clear answer before any decision is made.

In a tall bay, cool air settles low and hot air rises, which works in your favour when diffusers are aimed correctly at the working level and the racking. We set diffuser angles and positions during design based on the racking height and the movement aisles.

Cold rooms and freezer rooms run on their own refrigeration systems, which we install as a separate service. What we handle here is the ambient air around those room doors, so warm warehouse air does not rush in when they open, managed by pressure zoning between the two spaces.

Yes, especially ducts that run close to the hot metal roof. Without insulation, cool air gains heat before it reaches the diffusers and loses much of its effect. We insulate with Armaflex or Kimmco materials and seal joints with Foster sealants to stop air leaks.

Yes. In tall racking aisles the airflow path narrows and slows, so we choose directional diffusers that push air along the aisle length rather than spreading it sideways. In open floor areas we use wider-angle diffusers. The angle and position of each diffuser are set at design stage based on the aisle width and racking height.

Metal roofs absorb heat intensely, so we design a ducted system with air channels distributed across the full floor area, and sometimes add extra thermal insulation beneath the roof to reduce the cooling load.

Yes, we zone the warehouse by storage type or required temperature, for example, one area for standard goods and another for heat-sensitive materials, each with independent controls.

Yes, moisture and dust accumulate quickly in warehouses, so we design strong filters and easily cleanable air channels, with regular maintenance schedules to keep the system efficient.

Outdoor units are fixed to the metal roof or on custom-built metal frames to distribute their weight and prevent leaks at mounting points, raised above roof level to prevent water pooling.