Central AC installation in Al Shama'il

We calculate the thermal load for each zone based on its area, ceiling height, number of external openings, orientation and how it will be used. In Jeddah the sun's effect on west-facing facades is significant, and high humidity goes into the calculation. We choose the unit size after this calculation, not before.

We fabricate round and rectangular ducts in our own workshop from G90 galvanised sheet or aluminium sheet depending on what the project needs. This lets us cut ducts to the exact site dimensions and fit them tightly, avoiding ill-fitting sections that leak air and raise electricity consumption.

We use Mueller copper in runs of up to 30 metres without welded joints, which reduces potential leak points. If a run exceeds that, the survey determines whether the outdoor unit position needs rethinking or whether the refrigerant charge needs adjustment according to the type shown on the unit's nameplate.

Yes, and it is settled at the design stage. Each floor can have its own unit, or the network can be split into zones with dampers and a thermostat in each, so you do not cool the whole upper floor while the family sits in the majlis. We recommend the right option after the load calculation.

Yes, and the roof surface determines what kind of base is needed. For villas we fabricate a raised steel frame that keeps the unit clear of pooled rainwater and allows airflow beneath it. The exact height and angle depend on the roof pitch and the condensate drain position, which the site survey establishes. The aim is to keep the unit level and to prevent vibration movement during operation.

We calculate the cooling load for each room, then size the distribution vents and duct diameters accordingly. We test the system after installation to confirm even cold air reaches all areas.

Yes, we fabricate the ducts in the workshop to fit your suspended ceiling dimensions and available space. We coordinate with you beforehand to confirm the layout and ensure ducts don't cross electrical wires or water pipes.

We size the outdoor unit based on the load calculation, which accounts for the district's peak temperatures and your home's thermal insulation. We ensure the outdoor unit is adequately ventilated to handle the ambient heat.

We route the wires and copper carefully through the ducts or separate channels to avoid interference and faults. We confirm all connections are secure and the copper is properly insulated to prevent leaks or electrical failures.