Chiller maintenance in Al Mahjar

We measure suction and high-side pressure and compare them with expected values for the refrigerant type on the unit nameplate, check the compressor thermally with an infrared camera if needed, and compare current draw with actual load conditions on the day of the visit.

Yes. Jeddah's humid, salt-laden sea air deposits a layer on outdoor condenser coils faster than in dry inland cities. This raises condensing pressure and makes the compressor work harder, which is why coil inspection and cleaning matter more here than in a dry climate.

Most maintenance and common repairs are done on site: coil cleaning, pressure adjustment, sensor replacement, control circuit repair. Work that requires internal compressor rebuilding is identified after inspection and we explain exactly what it involves.

At every visit we record refrigerant pressures, entering and leaving water temperatures, compressor current and any alarms. Comparing these readings visit by visit shows a slow loss of performance, such as a condenser coil starting to foul or a charge running low, before it turns into a shutdown.

It depends on how many chillers the building has and how the hydronic circuit is designed. With a single chiller, a full inspection needs a brief shutdown agreed with you in advance. Where more than one chiller is installed, we schedule maintenance in sequence so partial cooling stays available. The first visit establishes what is possible.

A chiller is a complex unit that cools water distributed to every floor, unlike an independent split. We inspect the compressor, filters, refrigerant pressures, water flow and automatic controls closely to prevent a failure that would affect the entire building.

The chiller room is usually in the basement or on the roof. We coordinate with building management in advance to ensure safe access and adequate working space around the unit.

Regular cleaning of the condenser coils is essential because extreme heat increases pressure on the outdoor unit. We check pressures and flow monthly during summer to ensure the chiller operates at peak efficiency.

Yes, long pipe runs need regular checks for leaks, insulation and pressure. We verify water flow on each floor and ensure there are no blockages in distribution filters or valves.