Freezer and dual-temp rooms
Cold & freezer room installation in Al Nuzlah Al Sharqiyah
Cold and freezer room installation in Al Nuzlah Al Sharqiyah demands understanding of what sets them apart from standard chillers. Alrabih designs the room to fit your stock, meat, fish, ice cream or dual zones, with thick insulation, frost-resistant flooring and a protected door frame.
- Frost-proof floor
- Auto defrost
- Two-zone layout
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
Who needs a specialist freezer room?
- 1
Stock that needs sub-zero cold
Meat, poultry, fish and ice cream spoil if the temperature rises even briefly above the required level. A freezer room is built to hold that level continuously, not simply to cool.
- 2
One room, two temperature zones
Large restaurants and hotels usually need a chiller section and a freezer section side by side. We build both wings with separate insulation, independent refrigeration units and an insulated inner door, so neither zone affects the other's temperature.
- 3
Expanding an existing facility
If your current cold room no longer holds all your stock, or you need to add a freezer section beside it, we survey the site and propose the most practical way to expand with as little disruption to your operation as possible.
Who it's for
Opening a restaurant that needs a freezer room
We survey your kitchen and build the freezer room with frost-rated insulation panels, an insulated floor and a tight-sealing door.
Ask on WhatsAppNeed a chiller wing and a freezer wing together
We build both wings with separate insulation, independent refrigeration units and an insulated inner door between them.
Ask on WhatsApp
What the installation covers
- Freezer-rated insulation panels
- Insulated floor vapour barrier
- Heated frame tight-sealing door
- Evaporator with electric defrost
- Condensing unit temperature controller
How we work
How we work
- 1
Site survey
We visit the site, learn the stock type and required temperature, measure the available space, and decide the right insulation thickness and refrigeration system from what we find.
- 2
Design and supply
We draw the room layout including pipe and cable routes, then have the panels, doors and equipment ready before installation begins.
- 3
Installation and connection
We fit the panels, insulated floor and door, then run and insulate the copper pipes, vacuum the line and pressure-test it before starting the system. Mueller copper in runs of up to 30 metres without welded joints where the layout calls for it.
- 4
Start-up and handover
We run the system and watch the room reach its target temperature, confirm the defrost cycle works and the door seals properly, then explain the controls to the person responsible for the facility.
Specialist install or an unconsidered one?
| Alrabih | The usual way | |
|---|---|---|
| Floor | Insulated with vapour barrier | Plain floor that cracks |
| Door frame | Heated to prevent seizure | Freezes and warps |
| Evaporator | Scheduled electric defrost | Ice blocks the airflow |
| Insulation | Thickness set at survey | Same thickness for every room |
| Anteroom | Buffer zone reduces air ingress | Direct door into freezer |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Al Nuzlah Al Sharqiyah mixes small storage units, butcher shops, and medium-sized restaurants and cafés in relatively modern buildings. Each butcher or restaurant needs a dedicated freezer room to preserve daily stock, and the flat floors and open building gaps make it easier to move heavy equipment and install. Freezer rooms here are usually small to medium, built into a shop or store, and call for careful study of electrical isolation and water drainage to prevent ice buildup.
Al Nuzlah Al Sharqiyah lies in south Jeddah, a mixed-use district of storage units and commercial shops in modern buildings with open space between blocks.
Most freezer rooms installed here are 2 by 3 metres or smaller for butcher shops and restaurants, with outdoor refrigeration units mounted on the roof or outer wall.
The AC setup in Al Nuzlah Al Sharqiyah
- 1
Standalone freezer room for a butcher shop or restaurant
Commercial shops in Al Nuzlah Al Sharqiyah install a fully separate freezer room inside the shop, with the refrigeration unit mounted on the roof or outer wall.
- 2
Dual-zone freezer room for mixed stock
Larger restaurants and shops may need one room divided into two zones: full freezing for meat and fish, and moderate chilling for vegetables and other goods.
- 3
Freezer room in a small storage unit
Small storage units in the area install slightly larger freezer rooms, often 3 by 4 metres or more, to hold inventory for longer periods.
Before the visit
Before our visit in Al Nuzlah Al Sharqiyah
- 1
Pinpoint the exact location inside the shop or store
Tell us the planned location: main floor, a corner, or near storage, as this affects the design and installation approach.
- 2
Ensure the team and equipment can access easily
Check that corridors and doorways allow heavy equipment in, or tell us of any obstacles so we can plan the delivery correctly.
- 3
Check the floor, electrical and water lines
Verify the floor is level and strong, and tell us where the nearest electrical outlet and water drain are so we can design efficiently.
More districts for Cold & freezer room installation
Other services in Al Nuzlah Al Sharqiyah
FAQ
Questions about Cold & freezer room installation
Why does a freezer room need an insulated floor when a chiller often does not?
At sub-zero temperatures the moisture held in a concrete slab freezes and expands, cracking tiles and lifting bases over time. A chiller room operates above freezing, so ice crystals do not form in the slab. A freezer room therefore requires insulated panels under the floor together with a vapour barrier that blocks rising ground heat and protects the structure over the long term.
What is the difference between electric defrost and other types?
Electric defrost uses heating elements fixed inside the evaporator coil; they warm the coil directly and melt frost build-up. Hot-gas defrost instead redirects warm refrigerant from the compressor back through the same coil. The choice between the two depends on room size, the required number of cycles and the type of goods stored; the site survey determines which method suits each installation.
Can two zones at different temperatures share the same footprint?
Yes. A partition of insulated panels separates the space, with each side using a panel thickness matched to its required temperature differential. Each zone has its own refrigeration unit and a door with a heated frame to prevent condensation. This arrangement is widely used in meat and fish facilities that need a chiller zone for short-term stock and a freezer zone for longer storage. The final design depends on the available floor area and the heat load of each section.
Does the position of the condensing unit affect how the freezer room performs?
Position has a direct effect. The condensing unit needs clean air and adequate flow to reject heat; if it is placed in a confined space or near heat sources the condensing pressure rises and the compressor works harder. In Jeddah, outdoor air also carries salt and dust that accumulate on the condenser coil over time. The site survey identifies the best location and the copper-pipe route, keeping each Mueller copper pipe run within thirty metres without welded joints.
Does the position of the condensing unit affect how the freezer room performs?
Position has a direct effect. The condensing unit needs clean air and adequate flow to reject heat; if it is placed in a confined space or near heat sources the condensing pressure rises and the compressor works harder. In Jeddah, outdoor air also carries salt and dust that accumulate on the condenser coil over time. The site survey identifies the best location and the copper-pipe route, keeping each Mueller copper pipe run within thirty metres without welded joints.
I run a butcher shop in Al Nuzlah, what freezer room size would I need?
Room size depends on your daily stock volume and the space available in your shop. Our team visits your location, understands your business needs and recommends the right size, then sends a quote.
Our space is tight and the floor needs to be strong, is this possible in our shop?
Yes, we design the room to fit your available space, and we assess the floor's load-bearing capacity for the units and stock before we start.
The heat and humidity here are intense; will that affect the freezer room?
Yes, high temperatures and humidity increase the cooling load, so we select units with adequate capacity and thick insulation to maintain stable internal temperatures.
Our shop's wiring is old, will it handle a freezer room?
It depends on your existing circuit capacity and the unit size chosen. Our team inspects your electrical system and recommends any necessary upgrades before installation.
