Cold rooms kept running
Cold rooms in Al Tha'alibah
In Al Tha'alibah, south Jeddah, cold rooms in restaurants and food shops operate in cramped spaces and extreme heat. Alrabih's team diagnoses cooling faults and cleans the evaporator, compressor, controller and door seal to restore performance and efficiency.
- Accurate diagnosis
- Clean evaporator
- Sealed door
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When your cold room needs attention
- 1
Room not holding temperature
The temperature climbs slowly even though the unit keeps running, or the products inside are warmer than they should be. The cause could be the evaporator, condensing unit, refrigerant level or controller, and only a site check tells which.
- 2
Evaporator icing up and stopping
Ice builds on the evaporator until airflow stops and cooling fails. The cause is usually in the defrost circuit, its sensor or the evaporator fan. Jeddah's humid air speeds up icing when anything in that circuit is not working correctly.
- 3
Door letting cold air escape
A worn or deformed door seal lets warm humid air in, overloading the refrigeration unit and speeding up evaporator icing. If the door frame heater has failed, moisture builds on the frame and the door becomes hard to open.
Who it's for
Running a restaurant or central kitchen cold room
We check the evaporator, defrost circuit and door seal in your kitchen cold room and fix any fault before your food stock is put at risk.
Ask on WhatsAppOperating a freezer room in a warehouse or retail outlet
We find the cause of temperature loss in your freezer room, inspect the rooftop condensing unit, controller and alarm, and complete a full running test before we leave.
Ask on WhatsApp
What the service covers
- Evaporator check and clean
- Defrost circuit and sensors
- Door seal and frame heater
- Rooftop condensing unit inspection
- Controller and temperature alarm
How we work
How we work
- 1
Describe the fault
WhatsApp us what you see: the temperature showing on the controller, whether the unit is running or not, and the type of stock inside the room.
- 2
Site check and diagnosis
The technician checks the evaporator, condensing unit, defrost circuit, controller and door seal, then identifies the actual cause of the temperature loss before starting any work.
- 3
Repair and replacement
We fix what the diagnosis found: clean the evaporator, repair the defrost circuit, replace the seal or adjust the refrigerant charge to the type written on the unit nameplate.
- 4
Test and handover
We run the room and watch the temperature until it reaches the set value, confirm the alarm and controller are working, then hand you a report of what was done.
Systematic maintenance or a quick temporary fix?
| Alrabih | The usual way | |
|---|---|---|
| Diagnosis | Root cause first | Symptom fixed only |
| Evaporator | Checked and cleaned | Ignored until it stops |
| Door seal | Checked, adjusted or replaced | Left until obviously leaking |
| Controller and alarm | Tested before leaving | Not checked |
| Post-visit report | Written record of work done | Verbal summary only |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Al Tha'alibah is a relatively older working-class district in south Jeddah, densely packed with small restaurants, cafés and food shops in closely built blocks and narrow streets. Storage space is very limited and natural ventilation poor due to building density. Extreme heat, humidity and intensive use cause rapid buildup of dust and mould on coils and seals. All of this makes regular deep maintenance and frequent cleaning essential to maintain stable cooling and prevent stock loss.
Al Tha'alibah sits in south Jeddah, an older working-class district with closely built blocks, narrow streets and small restaurants.
Cold rooms here are usually very small units with top-mounted evaporator and outdoor compressor on roof or balcony, due to tight indoor space.
The AC setup in Al Tha'alibah
- 1
Very small room with top evaporator and roof or balcony compressor
Extreme space constraints in Al Tha'alibah force very small room setups, with the outdoor unit usually on the roof or a narrow balcony.
- 2
Thin door seal prone to rapid damage
The seal in small older rooms may be thin and easily worn by repeated opening and closing.
- 3
Simple controller in a hot and damp location
The controller may be near heat or moisture sources, affecting temperature accuracy and button response.
Before the visit
Before our visit in Al Tha'alibah
- 1
Identify the nearest parking and safe access route
Streets in Al Tha'alibah are very narrow, help us identify the nearest safe parking and route to the restaurant or shop.
- 2
Ensure access to the roof or balcony is possible
Verify the roof or balcony with the outdoor unit is safe and accessible before the visit.
- 3
Tell us the current temperature setting and cooling performance
If the room is not holding temperature or the controller is inaccurate, brief us on the issue before we visit so we prepare accordingly.
More districts for Cold rooms
Other services in Al Tha'alibah
FAQ
Questions about Cold rooms
Why does the temperature rise even though the unit runs all the time?
Continuous running does not mean correct operation. Common causes include a refrigerant leak that reduces the charge, heavy frost on the evaporator coil blocking airflow, or a fault in the rooftop condensing unit raising head pressure. A site survey identifies the actual cause before any work begins.
How do I know if the defrost cycle is working properly?
Clear signs of a defrost fault include thick frost covering the full evaporator coil, a gradual temperature rise while the unit keeps running, and water pooling on the floor instead of draining away. The check covers the heater element, the defrost sensor and the controller, as the fault can lie in any of these parts.
What does a preventive visit for a cold room cover?
A preventive visit covers a pressure check on the refrigeration circuit, cleaning the condenser and evaporator coils, inspecting door seals and frame heaters, testing the controller and alarm, and checking copper pipe connections. The aim is to find a developing fault before it affects the room temperature and the stock inside.
What is the difference between a preventive visit and a repair visit?
A preventive visit is carried out on a unit that is running normally: the purpose is inspection, cleaning and finding early signs of wear before they become a breakdown. A repair visit is requested when an actual fault appears, such as a rising temperature, a stopped compressor or excessive coil icing. Diagnosis comes first, then the required work is defined.
Does Jeddah's rooftop heat affect the condensing unit's performance?
Yes. In summer, Jeddah rooftop surfaces reach very high temperatures, which raises condensing pressure, stresses the compressor and reduces cooling capacity. Regular cleaning of the condenser coil to remove the dust and salt that cling to the fins is essential, not optional. A site survey determines whether the unit's position or the airflow around it is making the problem worse.
My restaurant in Al Tha'alibah is cramped, can you fit the outdoor unit?
We examine options on the roof, balcony or exterior wall, and coordinate with the building owner to choose the best spot without infringing on neighbours.
The street is very narrow and access is difficult, how do you bring the equipment?
We carry tools by hand from the nearest parking point, and we agree with you on the closest and safest access route before the visit.
The heat here is extreme and the room loses cold quickly, is that normal?
Extreme heat and humidity in Al Tha'alibah increase evaporator strain, so we clean coils every four weeks and check refrigerant and seals regularly.
The restaurant's wiring is old, does it affect the cold room?
We check the electrical circuit and safety breaker, ensure the connection is safe and can handle the load, and advise on updating wiring if it is weak.
