AC duct manufacturing in Southern Housing

We close the long seams with a tight mechanical lock as the sheet is formed, then seal every seam and every joint between sections with Foster sealant before insulating. Sections leave the workshop with matching flanges that tighten evenly when hung, because any small gap in cold duct means lost air and a point where condensation forms.

Sections arrive fabricated, insulated, sealed and numbered to the route drawing, so the fitters know where each piece goes without cutting or altering on site. What is left on site is joining the sections, fixing them to the hangers and connecting the unit and outlets, which shortens the work above the ceiling.

Yes, we fabricate plenums for both types. A cassette unit plenum is measured to match the unit's outlet frame exactly so air reaches the branch runs without leaking at the connection. A cabinet unit plenum is made to carry both the supply and return paths if the design calls for it. Both types are insulated with Kimmco or Armaflex and sealed with Foster sealant before they leave the workshop.

Yes. The workshop is equipped to fabricate large supply and return trunk runs suited to commercial, government and industrial buildings. Each section is made to the project drawings, numbered and delivered ready to hang after insulation and sealing. When engineering drawings are available, the technical team reviews them before fabrication starts to confirm that the duct dimensions fit the ceiling voids on site.

The duct carries cold air through a ceiling void that may be hot and humid. Without external insulation, water vapour condenses on the cold sheet and drips onto the false ceiling or the goods below. So each section is wrapped in Kimmco or Armaflex in our workshop and every edge and joint is sealed with Foster sealant before delivery.

Yes, we make standardised ducts for each building type in the project. Villas need horizontal runs to unified dimensions, flats need vertical ducts to matching dimensions too, and the whole project benefits from standardised production.

We divide delivery into phases matching your project schedule, supply ducts with clear numbering per phase, and coordinate delivery timing with your installation readiness.

Full insulation with heavy-duty foam and Foster sealing at every joint is fundamental. We manufacture ducts to high-pressure standards able to withstand extreme heat and high humidity over the long term.

We make unified ducts for each unit type (studio, large flat, villa), with each type getting standard-dimension ducts matching its cooling needs.