Fridge & freezer service in Kinanah

In fridges with a back-wall evaporator, the air-circulation fan may have stopped or be blocked by ice, so cold air reaches the top shelf but does not spread down. The thermostat position or a blocked air duct can also cause this. The technician identifies the real cause on site because the answer varies by model.

Usually not. Frost build-up most often points to a fault in the automatic defrost cycle, such as the defrost heater, timer or thermal fuse, not a low refrigerant charge. A low charge shows as weak cooling and a hot compressor, not frost. The on-site check tells the difference clearly.

Many faults, including the fan, thermostat, drain and door seal, are fixed without emptying or moving the fridge. When a forced defrost is needed we ask you to move food off the shelves temporarily. We let you know this when we book the visit so you are ready.

There is no single rule that fits every unit, but we weigh the fridge's age, the cost and availability of the needed part, and the condition of the rest of the unit. If our technician judges that the repair cost does not justify the remaining life of the fridge, he says so clearly before any work begins.

Yes. A fridge is designed to work within a set ambient temperature range. When placed in a poorly ventilated kitchen or near a heat source, the compressor works harder than it was built for. This speeds up wear and raises electricity consumption. The technician checks the unit's position and the room ventilation as part of the diagnosis.

Desert heat can exceed 50°C outside, putting huge strain on the compressor and condenser. We inspect the coils, compressor and oil, clean dust, and make sure ventilation around the fridge is excellent. We may suggest extra sun protection if needed.

Yes, very much. Fine dust and shifting humidity clog the coils and condenser, and may cause the evaporator to freeze or the pan to leak. We advise monthly coil cleaning and installing dust protection around the unit if possible.

Dust, salt, and sediment in the water in Kinanah quickly clog drain lines. We clean the lines and may use a special cleaning solution for salt and sediment. We recommend checking the line every two months.

The compressor may fail because of intense heat, depleted oil, and coils clogged with dust. We inspect it and tell you whether it can be repaired or replacement is better. In extreme heat cases, we may suggest a higher-capacity compressor.