Hospital HVAC in Al Hamra

Ventilation needs vary from one department to the next based on the activity in each area and the requirements set by the facility's designer and the site survey. Operating theatres need highly filtered, directionally controlled air, while patient rooms, corridors and administrative areas each carry different requirements. We build the duct network and select units from the facility's drawings and its specific requirements, not from general assumptions.

Yes, but it requires careful planning before the maintenance date. We agree with facility management on a schedule that names the section and the right time window, then isolate the target section using dampers and blanking plates without affecting adjacent departments. Corrective tasks such as replacing a capacitor or repairing a flare joint are carried out within the agreed time window.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

We work with medical facilities of all sizes, from a clinic in a residential district to a multi-storey medical complex. The size of the facility does not change the principle: the site survey is the starting point, and from it we determine unit types, duct dimensions and fresh-air requirements for each zone. Preventive and corrective maintenance contracts are available for clinics and hospitals alike.

Usually no, because tight spaces and old ceilings cannot easily accommodate extended ductwork. The best solution is typically powerful split units distributed across waiting areas and consulting rooms, or upgrading the window AC if present. We visit and suggest the most suitable option.

Yes, commercial activity and heavy foot traffic increase dust and pollutant concentration. We fit stronger filters and clean them more frequently. We inspect filters monthly where possible instead of quarterly.

We install separate split units for the operating room with precise thermostats, and weaker separate units for consulting and waiting areas. Each unit has its own control, giving flexibility to adjust temperatures per area.

Yes, we need sufficient power for the compressor and fan, and a safe drain line for condensation water. We check electrical circuits and pipes before installation. If capacity is limited, we may recommend smaller units or wise power distribution.