Hotel and hospitality HVAC
Hotel HVAC in Obaid
In Obaid, South Jeddah, small and mid-sized hotels need AC that gives guests independent temperature control in their rooms. Alrabih designs centralised HVAC systems with individual room controls and proper ventilation for corridors and lobbies.
- Room quiet
- Individual control
- Non-disruptive maintenance
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When a hotel needs a specialist
- 1
A new hotel or serviced apartments under construction
The right design starts before the ceilings are closed. We fix diffuser positions, duct routes and noise levels per room before finishing, so there is no costly breaking out or rerouting later.
- 2
Guests complaining about noise or smell
A loud fan coil, air whistling at a diffuser, or corridor smell entering the room when the door opens. These are diagnosable problems with a fix, after a site survey of the airflow.
- 3
Maintenance that disrupts hotel operations
A hotel never stops, and occupied rooms cannot accept a technician working through the night. We draw the maintenance plan with the hotel manager, using vacant rooms and quiet hours.
Who it's for
Opening a new hotel before fit-out is finished
We enter at the structural stage to fix duct routes and unit positions for every room before ceilings close, so you avoid costly changes later.
Ask on WhatsAppRunning an open hotel with ongoing guest complaints
We diagnose noise, odour and control faults in problem rooms and carry out repairs in vacant rooms without affecting staying guests.
Ask on WhatsApp
What the work covers
- Design for rooms and areas
- Supply and installation of units
- Ductwork to SMACNA standards
- Fresh air and odour control
- Preventive and corrective maintenance contracts
How we work
How we work
- 1
Survey and design
We visit the site, study the drawings and expected occupancy, and decide the right system type for each zone: rooms, lobby, halls and corridors.
- 2
Fabrication and supply
We fabricate ducts in our own workshop from G90 galvanised sheet to the site dimensions, and supply units from our authorised brands to the specifications the design sets.
- 3
Installation and sealing
We install units and ducts and test room noise levels before the ceilings close, using Armaflex and Kimmco insulation and Foster sealants to control condensation and air leakage.
- 4
Handover and maintenance plan
We commission the full system, verify individual control in every room, and hand hotel management a scheduled maintenance plan built around occupancy so guests are not disturbed.
Specialist hotel design or a generic fit-out?
| Alrabih | The usual way | |
|---|---|---|
| Room noise | Measured and set before close-up | Found after opening |
| Guest control | Independent per room | One zone per floor |
| Corridor odour | Planned fresh-air supply | Enters guest rooms |
| Maintenance | Scheduled with hotel management | When a technician is free |
| Corridor air quality | Calculated pressure stops infiltration | Relies on opening windows |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Obaid has a mix of older and newer hotels, some built with designs that lack adequate thermal insulation between rooms, others needing upgrades to ageing AC systems. The hot climate and seasonal humidity increase the cooling load, and guests expect precise temperature control without hearing noise from the corridors. System design must balance efficiency, quiet operation and maintenance that does not disturb occupied rooms.
Obaid lies in South Jeddah and holds small hotels and an industrial park, with a mix of older and newer buildings.
Most hotels here use centralised AC systems with separate controls per floor or zone, though some need upgrading to independent room control.
The AC setup in Obaid
- 1
Centralised AC with separate room control
Centralised systems here deliver high efficiency while each room has its own thermostat and control valve for independent temperature adjustment.
- 2
Outdoor units distributed across roof and walls
In Obaid's older hotels, outdoor units are spread across the roof and external walls to avoid excess weight on a single roof area.
- 3
Separate ventilation for corridors and lobbies
Corridors and lobbies need independent ventilation with dehumidification to ensure guest and staff comfort and reduce odours.
Before the visit
Before our visit in Obaid
- 1
Obtain the hotel's architectural plans
Tell us the number of rooms, floors and overall layout so we can estimate system requirements before the first visit.
- 2
Identify possible outdoor unit locations
Tell us where outdoor units can be mounted (roof, external walls, any constraints) so we can choose the best option.
- 3
Coordinate with hotel management on visit times
Agree with management on a visit time that does not disrupt hotel operations or guest comfort.
More districts for Hotel HVAC
Other services in Obaid
FAQ
Questions about Hotel HVAC
What unit type suits hotel guest rooms in Jeddah?
It depends on the building layout, number of floors and running-cost priorities. Fan coil units on a chilled-water system are common in larger hotels; serviced apartments often suit split or cassette units. The survey decides what fits, and both options are available through our authorised brands: Carrier, YORK, General, Midea, Gree and Smart Gold.
How do you handle Jeddah's humidity in corridors and shared areas?
Indoor corridors face humid outside air every time a door opens. We calculate the fresh-air volume for each zone and check that internal pressure stops warm, humid outside air from infiltrating. Ducts are insulated with Kimmco and Armaflex materials to stop condensation forming on the outside of the duct.
Can you service one room without cutting air conditioning to the rest of the floor?
In most systems designed for hotels, yes. Each unit or circuit serves a limited set of rooms and can be isolated on its own. We build this zoning into the design specifically so that neighbouring rooms stay live during any maintenance work, and the zoning is confirmed at the design stage before installation.
Do you work in the hotel while it is open to guests?
Yes, and we are familiar with coordinating around hotel operations. We agree in advance which rooms are set aside for maintenance, and we work at hours that avoid guest peak times. Any task that produces noise is reviewed with the hotel manager before it is scheduled.
How do you maintain stable room temperature when guests change and doors open frequently?
Frequent door opening upsets the pressure balance in a guest room and lets warm, humid corridor air in. We size each unit to the actual room dimensions, not the building as a whole, and balance the fresh-air supply against the return air for each room. A site survey determines the layout of individual controls and the dampers needed to isolate each room from corridor pressure changes.
How do you ensure a guest can control the temperature in their room?
We design a centralised system with a separate thermostat in each room, allowing guests to adjust the temperature within a safe range without compromising overall efficiency.
The hotel is older and the roof cannot take large outdoor units, how do you solve this?
We assess the hotel's location and roof capacity first, and can distribute the outdoor units across different locations or use horizontal or vertical units to match the available space.
Humidity in South Jeddah increases odour in the corridors, does your system address this?
We design separate ventilation for corridors and lobbies with appropriate dehumidification to prevent odour buildup, plus regular filter maintenance.
When can you repair AC without disturbing guests?
We coordinate with hotel management to schedule maintenance during suitable hours, often early morning or between guests, and work efficiently to minimise downtime.
