Operation & maintenance contracts in Harat Al Sham

We cover both. Our team operates the plant daily: monitoring circuit pressures, water temperatures and flow rates, logging control-panel readings, and adjusting settings to match the load. Alongside daily operation, the contract includes preventive and corrective maintenance, with regular reports submitted to facility management.

Preventive maintenance means inspecting components while they are still running: cleaning AHU coils, checking pump belts and fan bearings, verifying copper-pipe connections, and testing condenser and evaporator performance. Corrective maintenance starts when an actual fault is found, such as a tripping breaker, a degraded capacitor or a circuit leak, and the goal is to restore full plant performance.

Yes. Many facilities combine equipment from several manufacturers on a single network. Our team works with Carrier, YORK, General, Midea, Gree and Smart Gold equipment within one unified operating system. When a contract covers multi-brand equipment, the initial site survey sets the specific procedures for each unit.

The technician records the finding in the inspection log and notifies the facility supervisor immediately. The extent of the damage and its effect on the rest of the plant is assessed, then the part is replaced or repaired under corrective maintenance before the fault develops and disrupts operation. The full incident is entered in the visit report.

We record the finding immediately in the round log and inform facility management of the part and the cause of the wear. After approval we replace the part and record it in the maintenance report. The final decision stays with you, and identifying the right part depends on the unit specifications noted in the survey.

We carefully inspect ducts and pipes integrated within stonework, use thermal imaging to detect wall leaks, and monitor humidity around each mounting point.

We carry tools by hand and smaller equipment over our shoulders, coordinate with hotel or museum management for the nearest safe gate, and schedule visits in advance to avoid congestion.

We check humidity levels in ducts and rooms monthly, ensure pipes are properly insulated, balance temperatures to reduce condensation on stone walls, and clean filters and evaporators more frequently.

We inspect ducts with small cameras to detect blockages and corrosion, use low-pressure cleaning to avoid damage, and document duct condition, recommending replacement if needed.