Fitted right first time
Split AC installation in Umm Hablain Al Gharbiyah
Split AC installation in Umm Hablain Al Gharbiyah requires precision in unit placement, insulated copper and proper drainage. We vacuum the line before start-up for quiet, drip-free cooling from day one.
- Mueller copper
- Full vacuum
- Proper drain
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When you need a proper installer
- 1
A new unit for a room or flat
You have bought the unit, or are about to, and want it fitted once, not to find a refrigerant leak or water on the floor a few weeks later. Getting it right first time saves you all of that.
- 2
Not sure where the outdoor unit goes
In Jeddah flats the choice is usually the roof, the balcony or the facade. We pick a spot where the condenser gets enough air, a technician can reach it for servicing, and neither noise nor drain water bothers the neighbours.
- 3
A past install that went wrong
Weak cooling since day one, water running down the wall, a loud indoor unit. These are usually installation mistakes, not faults in the unit, and our installation is built step by step to avoid them.
Who it's for
Moving into a new flat that needs AC
We plan every unit position and copper route in one go, so the whole flat ends up neat and consistent.
Ask on WhatsAppFitting AC in a shop or office
We place the units so cool air reaches the entrance and the work area, and arrange outdoor units and drains to suit the shopfront and the building's rules.
Ask on WhatsApp
What the installation covers
- Site check and unit positions
- Insulated copper, sealed wall core
- Drain line with correct fall
- Vacuum and leak test
- Start-up test with you present
How we work
How we work
- 1
Send a photo
WhatsApp us a photo of the room, where the outdoor unit might go and your district, and we tell you what the job needs before the visit.
- 2
Agree positions and route
On site, the technician agrees the unit positions and the copper and drain route with you before drilling any wall.
- 3
Fit and vacuum
We mount both units, run and insulate the copper, then vacuum the line with a pump and check the joints before releasing the refrigerant held in the outdoor unit.
- 4
Start-up and handover
We run the unit, measure the air coming out, check the drain flows, then leave the room clean and show you the remote and how to clean the filter.
A careful install or a rushed one?
| Alrabih | The usual way | |
|---|---|---|
| Vacuum | Pumped before start-up | Often skipped |
| Copper | Mueller, fully insulated | Patchy insulation |
| Drain | Falls, so no drips | Water down the wall |
| Outdoor unit spot | Airy and easy to reach | Wherever it fits |
| Wall opening | Sealed tight | Dust gets through |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Umm Hablain Al Gharbiyah is a relatively modern district mixing family villas and residential flats with varied outdoor space. The area layout is open and buildings well spaced, offering good access to roofs and outer walls. This villa-and-apartment mix allows professional unit installation with safe copper runs and orderly water drainage without major complexity.
Umm Hablain Al Gharbiyah sits in East Jeddah as a modern district mixing villas and apartment blocks with open spacing.
Villas and flats in Umm Hablain Al Gharbiyah typically need separate split units, with outdoor units usually mounted on roofs or south and east-facing walls.
The AC setup in Umm Hablain Al Gharbiyah
- 1
Separate split unit per residential unit
Varied-sized villas and flats in Umm Hablain need separate units based on space size and use.
- 2
Outdoor units on roofs and courtyards
Well-spaced buildings offer multiple options for outdoor unit mounting on roofs or in rear courtyards.
- 3
Insulated and safe copper runs
Reasonable distances between units allow efficient insulated copper runs without performance loss.
Before the visit
Before our visit in Umm Hablain Al Gharbiyah
- 1
Specify preferred outdoor unit location
Tell us if you prefer roofs or rear courtyards, and whether there is shade or structural constraints.
- 2
Confirm nearby and adequate electrical circuit
Check that the nearby electrical circuit can handle the unit capacity required.
- 3
Identify safe water drainage route
Tell us where the drain line can run safely away from building walls, foundations and occupied areas.
More districts for Split AC installation
Other services in Umm Hablain Al Gharbiyah
FAQ
Questions about Split AC installation
Will you install a unit I bought elsewhere?
Yes, we install units you have bought yourself. Before the visit we ask the model, its capacity and where both units will go, so we know the copper length. If you have not bought one yet, we are an authorised distributor for Carrier, YORK, General, Midea, Gree and Smart Gold and can help you choose.
Why does the line need vacuuming before start-up?
New pipes hold air and moisture, and Jeddah's humid air adds more. Mixed with refrigerant, they weaken cooling and strain the compressor over time. We pull them out with a vacuum pump, watch that the reading holds so we know the line is tight, and only then release the refrigerant.
Can the outdoor unit be far from the room?
Yes, within the manufacturer's limits for line length and height difference. We use Mueller copper in runs of up to 30 metres without welded joints, so there are fewer joints that could leak, and the survey shows whether a long run needs extra refrigerant.
Can you hide the copper and cables in the wall?
It depends on the house. In a new build or during finishing works, the copper can run inside the wall before plastering. In a lived-in home we use neat plastic trunking in the wall colour. We show you the better option for your home at the survey, before any work starts.
What if the outside wall cannot carry the unit?
We check the wall before fixing anything, because some facades are clad in stone or panels that cannot take the weight. Then we set the unit on a floor stand on the roof or balcony, or on a bracket anchored to the concrete itself, not the cladding, so it does not shake loose.
Flats and villas vary widely in size here, how do you choose the right capacity?
Capacity depends on space size, insulation and usage. We measure the site, ask about your needs and offer a quote suited to your case.
Some villas have narrow rear courtyards, does this affect outdoor unit mounting?
Tight spaces demand precision in position and anchoring. We choose the safest spot in the courtyard or on side walls if possible.
Heat here is intense and humidity variable, does this affect performance?
We fully vacuum the copper line to prevent moisture and carefully choose the outdoor unit position. We recommend regular maintenance to maintain efficiency in variable conditions.
Electrical runs may be distant, how do you handle that?
We ask about the breaker panel location and available circuits. If the run is long, we may need an additional circuit or electrical consultation before starting.
