Warehouse HVAC in Umm Hablain Al Sharqiyah

It depends on indoor humidity levels and the type of stock stored. In well-ventilated open areas where stock is not sensitive to a small rise in humidity, evaporative cooling can work well. The site survey gives a clear answer before any decision is made.

In a tall bay, cool air settles low and hot air rises, which works in your favour when diffusers are aimed correctly at the working level and the racking. We set diffuser angles and positions during design based on the racking height and the movement aisles.

Cold rooms and freezer rooms run on their own refrigeration systems, which we install as a separate service. What we handle here is the ambient air around those room doors, so warm warehouse air does not rush in when they open, managed by pressure zoning between the two spaces.

Yes, especially ducts that run close to the hot metal roof. Without insulation, cool air gains heat before it reaches the diffusers and loses much of its effect. We insulate with Armaflex or Kimmco materials and seal joints with Foster sealants to stop air leaks.

Yes. In tall racking aisles the airflow path narrows and slows, so we choose directional diffusers that push air along the aisle length rather than spreading it sideways. In open floor areas we use wider-angle diffusers. The angle and position of each diffuser are set at design stage based on the aisle width and racking height.

We calculate the heat load based on floor area, ceiling height, solar absorption by the metal, and heat generated by machinery inside, then select unit or units with sufficient capacity, which may be larger than expected due to extra heat sources.

Open doors are a major challenge, so we recommend air curtains or strip doors at entrances to cut hot air ingress, while ensuring the cooling system itself has high capacity to compensate for the loss.

Yes, high humidity raises the load on the condenser and speeds up rust and mould formation, so we select units with strong humidity drainage and recommend maintenance every two months to clean filters and drains.

Absolutely, machinery heat significantly raises the load, so we ask about equipment type and daily operation, and may need higher-capacity units or supplemental local cooling for the most heat-intensive areas.