Central AC installation in Al Widad

We calculate the thermal load for each zone based on its area, ceiling height, number of external openings, orientation and how it will be used. In Jeddah the sun's effect on west-facing facades is significant, and high humidity goes into the calculation. We choose the unit size after this calculation, not before.

We fabricate round and rectangular ducts in our own workshop from G90 galvanised sheet or aluminium sheet depending on what the project needs. This lets us cut ducts to the exact site dimensions and fit them tightly, avoiding ill-fitting sections that leak air and raise electricity consumption.

We use Mueller copper in runs of up to 30 metres without welded joints, which reduces potential leak points. If a run exceeds that, the survey determines whether the outdoor unit position needs rethinking or whether the refrigerant charge needs adjustment according to the type shown on the unit's nameplate.

Yes, and it is settled at the design stage. Each floor can have its own unit, or the network can be split into zones with dampers and a thermostat in each, so you do not cool the whole upper floor while the family sits in the majlis. We recommend the right option after the load calculation.

Yes, and the roof surface determines what kind of base is needed. For villas we fabricate a raised steel frame that keeps the unit clear of pooled rainwater and allows airflow beneath it. The exact height and angle depend on the roof pitch and the condensate drain position, which the site survey establishes. The aim is to keep the unit level and to prevent vibration movement during operation.

Yes, we can design one central system serving a cluster of adjacent villas if they are connected or very close. We examine the plan, measure the gaps between units and calculate total loads to design a balanced system.

We pinpoint the outdoor unit location in coordination with villa owners or complex management, usually in a protected shared space or an agreed-upon elevated spot. We confirm safe access for future maintenance.

Yes, east Jeddah gets long direct sun exposure, so we calculate thermal load based on actual exposure for each building section. We may use external shading or position the outdoor unit away from direct sun to improve efficiency.

Modern central units draw substantial power, so we inspect the electrical panel and calculate consumption. If the existing circuit is insufficient, we recommend upgrading it before installation or adding a dedicated circuit.