Duct cleaning & sanitising in Al Ta'awun

The filter catches dust before it enters the duct, but over the years fine particles slip through and stick to duct walls. If the filter is clean but the smell or allergy symptoms continue, the problem is likely deeper inside. A camera inspection shows the actual condition of the duct and settles the question.

Yes. The humid salty air from the sea enters through return-air openings carrying water vapour that condenses on the cool duct walls. This creates conditions where mould and bacteria grow, especially in sections far from the unit where airflow is weaker. Sanitising after cleaning inhibits that growth.

In most cases yes. We pass the camera and cleaning tools through existing grilles and access points. If a section is too long or narrow for the tools to reach, we may need to cut an access door, and we explain that at the inspection before starting; any opening cut is resealed when the work is done.

Most people notice the smell drops from the first run, and less dust settles on surfaces. Respiratory and allergy symptoms often ease gradually because the duct is no longer pushing irritant particles into the room. Airflow can also improve if deposits were partly blocking the cross-section.

Yes. If the camera shows that buildup is concentrated in a specific section, such as a duct near a return-air opening or an external passage, that section can be isolated and cleaned on its own. The inspector defines the logical work boundaries at the first visit so sections that need no work are not touched and sections that do are not missed.

We inspect the full shared duct from the central unit to the last branch, cleaning main and branch pipes and outlets in one go so all residents benefit from clean air.

We recommend annual duct cleaning at minimum, and if you notice strong musty smells or heavy dust from outlets, you may need additional cleaning every six months.

Yes, we shut down the entire central system for safety before cleaning starts, so all residents will experience temporary cool-air loss until the work finishes.

We open existing ceiling openings or remove panels if necessary, then pass the camera and tools through them to inspect and clean the pipes without structural damage.