Fridge & freezer service in Al Rabiyah

In fridges with a back-wall evaporator, the air-circulation fan may have stopped or be blocked by ice, so cold air reaches the top shelf but does not spread down. The thermostat position or a blocked air duct can also cause this. The technician identifies the real cause on site because the answer varies by model.

Usually not. Frost build-up most often points to a fault in the automatic defrost cycle, such as the defrost heater, timer or thermal fuse, not a low refrigerant charge. A low charge shows as weak cooling and a hot compressor, not frost. The on-site check tells the difference clearly.

Many faults, including the fan, thermostat, drain and door seal, are fixed without emptying or moving the fridge. When a forced defrost is needed we ask you to move food off the shelves temporarily. We let you know this when we book the visit so you are ready.

There is no single rule that fits every unit, but we weigh the fridge's age, the cost and availability of the needed part, and the condition of the rest of the unit. If our technician judges that the repair cost does not justify the remaining life of the fridge, he says so clearly before any work begins.

Yes. A fridge is designed to work within a set ambient temperature range. When placed in a poorly ventilated kitchen or near a heat source, the compressor works harder than it was built for. This speeds up wear and raises electricity consumption. The technician checks the unit's position and the room ventilation as part of the diagnosis.

Intense summer heat increases pressure on the compressor and coil, and if refrigerant is low or there is partial blockage, cooling fails quickly. Our team checks refrigerant level, coil and pipes to ensure the system works.

Yes, excess heat around the compressor increases refrigerant temperature and reduces cooling efficiency. Ensure there is good ventilation beneath the kitchen, and our team will check that hot air exhausts properly from the compressor.

Clicking may come from metal expansion due to heat or from the fan, and does not necessarily indicate serious failure. But if the noise persists, accurate inspection is important to identify the cause quickly.

Yes, sustained humidity and heat together speed corrosion on copper pipes, especially in older units. We inspect the pipes for corrosion and leak signs during the visit and tell you if they need replacing.