Hospital HVAC in Al Rehab

Ventilation needs vary from one department to the next based on the activity in each area and the requirements set by the facility's designer and the site survey. Operating theatres need highly filtered, directionally controlled air, while patient rooms, corridors and administrative areas each carry different requirements. We build the duct network and select units from the facility's drawings and its specific requirements, not from general assumptions.

Yes, but it requires careful planning before the maintenance date. We agree with facility management on a schedule that names the section and the right time window, then isolate the target section using dampers and blanking plates without affecting adjacent departments. Corrective tasks such as replacing a capacitor or repairing a flare joint are carried out within the agreed time window.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

We work with medical facilities of all sizes, from a clinic in a residential district to a multi-storey medical complex. The size of the facility does not change the principle: the site survey is the starting point, and from it we determine unit types, duct dimensions and fresh-air requirements for each zone. Preventive and corrective maintenance contracts are available for clinics and hospitals alike.

We assess each department's needs during the site survey. Usually we design one or two main compressors covering most departments, with small backup systems for critical areas. Operating and intensive care may need a separate compressor or full backup system.

We fit high-efficiency multi-stage filters in external ventilation systems, especially for operating and intensive care. We inspect and clean filters more frequently, and use activated charcoal radiators in some cases to remove odours and fine contaminants.

We run insulated copper lines between buildings underground or on exterior walls per the engineering plan. We may use multiple distributed compressors so each serves a building or department cluster. We rely on a full site survey to determine the best solution.

We schedule heavy routine maintenance during lower-service hours or weekend breaks in coordination with hospital management. For emergency maintenance and repairs, we use temporary backup units or isolate limited zones while keeping critical departments covered. We have an emergency team on standby.