Hospital HVAC in Al Sharafiyah

Ventilation needs vary from one department to the next based on the activity in each area and the requirements set by the facility's designer and the site survey. Operating theatres need highly filtered, directionally controlled air, while patient rooms, corridors and administrative areas each carry different requirements. We build the duct network and select units from the facility's drawings and its specific requirements, not from general assumptions.

Yes, but it requires careful planning before the maintenance date. We agree with facility management on a schedule that names the section and the right time window, then isolate the target section using dampers and blanking plates without affecting adjacent departments. Corrective tasks such as replacing a capacitor or repairing a flare joint are carried out within the agreed time window.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

We work with medical facilities of all sizes, from a clinic in a residential district to a multi-storey medical complex. The size of the facility does not change the principle: the site survey is the starting point, and from it we determine unit types, duct dimensions and fresh-air requirements for each zone. Preventive and corrective maintenance contracts are available for clinics and hospitals alike.

Yes, we schedule maintenance so that one or two wards are serviced at a time while the rest keep full cooling. We coordinate with hospital management before each visit to identify which wards can be maintained without affecting patients.

We install separate cooling systems for each critical ward with continuous monitoring of temperature and humidity. If one system fails, other wards remain unaffected, and routine maintenance keeps cooling stable.

Yes, ducts run across multiple floors, but distribution to each ward depends on outdoor-unit placement, piping and suspended ceilings. An on-site visit confirms that every ward receives adequate cold air.

Central systems include precise humidity monitoring, and filters and dehumidifiers are cleaned regularly to cut moisture and prevent mould growth in ducts and suspended ceilings.