Hotel and hospitality HVAC
Hotel HVAC in Al Atheer
In Al Atheer, south Jeddah, hotels and resorts need separate AC per guest room with independent temperature control. Alrabih designs centralised and distributed systems that give guests control and keep corridors and lobbies free of humidity and odour.
- Room quiet
- Individual control
- Non-disruptive maintenance
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When a hotel needs a specialist
- 1
A new hotel or serviced apartments under construction
The right design starts before the ceilings are closed. We fix diffuser positions, duct routes and noise levels per room before finishing, so there is no costly breaking out or rerouting later.
- 2
Guests complaining about noise or smell
A loud fan coil, air whistling at a diffuser, or corridor smell entering the room when the door opens. These are diagnosable problems with a fix, after a site survey of the airflow.
- 3
Maintenance that disrupts hotel operations
A hotel never stops, and occupied rooms cannot accept a technician working through the night. We draw the maintenance plan with the hotel manager, using vacant rooms and quiet hours.
Who it's for
Opening a new hotel before fit-out is finished
We enter at the structural stage to fix duct routes and unit positions for every room before ceilings close, so you avoid costly changes later.
Ask on WhatsAppRunning an open hotel with ongoing guest complaints
We diagnose noise, odour and control faults in problem rooms and carry out repairs in vacant rooms without affecting staying guests.
Ask on WhatsApp
What the work covers
- Design for rooms and areas
- Supply and installation of units
- Ductwork to SMACNA standards
- Fresh air and odour control
- Preventive and corrective maintenance contracts
How we work
How we work
- 1
Survey and design
We visit the site, study the drawings and expected occupancy, and decide the right system type for each zone: rooms, lobby, halls and corridors.
- 2
Fabrication and supply
We fabricate ducts in our own workshop from G90 galvanised sheet to the site dimensions, and supply units from our authorised brands to the specifications the design sets.
- 3
Installation and sealing
We install units and ducts and test room noise levels before the ceilings close, using Armaflex and Kimmco insulation and Foster sealants to control condensation and air leakage.
- 4
Handover and maintenance plan
We commission the full system, verify individual control in every room, and hand hotel management a scheduled maintenance plan built around occupancy so guests are not disturbed.
Specialist hotel design or a generic fit-out?
| Alrabih | The usual way | |
|---|---|---|
| Room noise | Measured and set before close-up | Found after opening |
| Guest control | Independent per room | One zone per floor |
| Corridor odour | Planned fresh-air supply | Enters guest rooms |
| Maintenance | Scheduled with hotel management | When a technician is free |
| Corridor air quality | Calculated pressure stops infiltration | Relies on opening windows |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Al Atheer has hotels ranging from small boutiques to large tourist resorts, many built in the last two decades to modern standards. Hotels need precise humidity control in shared corridors and lobbies, and each guest room needs its own independent cooling or heating loop. This type of system calls for maintenance at times that do not disturb guests, usually early morning or scheduled downtime.
Al Atheer sits in south Jeddah and is a hotel and resort district built to modern standards.
Most hotels here have centralised multi-zone AC systems or rooftop units with independent control per floor or room.
The AC setup in Al Atheer
- 1
Multi-zone centralised system with independent control
Modern hotels usually run a central cooling or heating unit with distribution ducting feeding each room through its own thermostatic valve and thermostat.
- 2
Separate rooftop units per wing or floor
Larger hotels may run several rooftop units, each serving a wing or floor, reducing crosstalk between rooms and simplifying independent maintenance.
- 3
Separate dehumidification for corridors and lobbies
Corridors and lobbies require lower humidity than rooms, so we dedicate a separate section of the system to keep shared areas free of dampness and odour.
Before the visit
Before our visit in Al Atheer
- 1
Confirm which wings and rooms are currently occupied
Before we visit, tell us which rooms are occupied so we can avoid disturbing guests and focus on vacant rooms and shared areas.
- 2
Confirm roof and outdoor unit access
Check that the roof is safe to access and the outdoor units can be serviced, and let us know of any security restrictions or metal structures that might hinder movement.
- 3
Arrange a meeting with the hotel or maintenance manager
We need to coordinate with the hotel or maintenance manager to understand available service windows and which areas need priority attention.
More districts for Hotel HVAC
Other services in Al Atheer
FAQ
Questions about Hotel HVAC
What unit type suits hotel guest rooms in Jeddah?
It depends on the building layout, number of floors and running-cost priorities. Fan coil units on a chilled-water system are common in larger hotels; serviced apartments often suit split or cassette units. The survey decides what fits, and both options are available through our authorised brands: Carrier, YORK, General, Midea, Gree and Smart Gold.
How do you handle Jeddah's humidity in corridors and shared areas?
Indoor corridors face humid outside air every time a door opens. We calculate the fresh-air volume for each zone and check that internal pressure stops warm, humid outside air from infiltrating. Ducts are insulated with Kimmco and Armaflex materials to stop condensation forming on the outside of the duct.
Can you service one room without cutting air conditioning to the rest of the floor?
In most systems designed for hotels, yes. Each unit or circuit serves a limited set of rooms and can be isolated on its own. We build this zoning into the design specifically so that neighbouring rooms stay live during any maintenance work, and the zoning is confirmed at the design stage before installation.
Do you work in the hotel while it is open to guests?
Yes, and we are familiar with coordinating around hotel operations. We agree in advance which rooms are set aside for maintenance, and we work at hours that avoid guest peak times. Any task that produces noise is reviewed with the hotel manager before it is scheduled.
How do you maintain stable room temperature when guests change and doors open frequently?
Frequent door opening upsets the pressure balance in a guest room and lets warm, humid corridor air in. We size each unit to the actual room dimensions, not the building as a whole, and balance the fresh-air supply against the return air for each room. A site survey determines the layout of individual controls and the dampers needed to isolate each room from corridor pressure changes.
How can I ensure each guest room has independent temperature control?
Modern centralised systems use thermostatic valves and separate sensors in each room so guests control the temperature independently of neighbouring rooms. We design the system to give each room its own air path.
Corridors and lobbies need very low humidity, is that achievable?
Yes, by installing a separate dehumidifier or a dedicated dehumidification section in the central system, corridors can be kept below 50 per cent humidity while maintaining guest comfort in rooms.
The hotel runs 24 hours, how do you carry out maintenance?
We schedule routine maintenance during low-demand periods, usually early morning before guests wake or during agreed downtime windows set with the hotel in advance.
The outdoor units are on the roof, do they cause noise in rooms?
Noise depends on the unit type and roof insulation. We select low-noise units and recommend additional acoustic insulation around the outdoor units to reduce any sound reaching upper floors.
