AC duct manufacturing in Al Najmah

We close the long seams with a tight mechanical lock as the sheet is formed, then seal every seam and every joint between sections with Foster sealant before insulating. Sections leave the workshop with matching flanges that tighten evenly when hung, because any small gap in cold duct means lost air and a point where condensation forms.

Sections arrive fabricated, insulated, sealed and numbered to the route drawing, so the fitters know where each piece goes without cutting or altering on site. What is left on site is joining the sections, fixing them to the hangers and connecting the unit and outlets, which shortens the work above the ceiling.

Yes, we fabricate plenums for both types. A cassette unit plenum is measured to match the unit's outlet frame exactly so air reaches the branch runs without leaking at the connection. A cabinet unit plenum is made to carry both the supply and return paths if the design calls for it. Both types are insulated with Kimmco or Armaflex and sealed with Foster sealant before they leave the workshop.

Yes. The workshop is equipped to fabricate large supply and return trunk runs suited to commercial, government and industrial buildings. Each section is made to the project drawings, numbered and delivered ready to hang after insulation and sealing. When engineering drawings are available, the technical team reviews them before fabrication starts to confirm that the duct dimensions fit the ceiling voids on site.

The duct carries cold air through a ceiling void that may be hot and humid. Without external insulation, water vapour condenses on the cold sheet and drips onto the false ceiling or the goods below. So each section is wrapped in Kimmco or Armaflex in our workshop and every edge and joint is sealed with Foster sealant before delivery.

Yes, we manufacture complete duct networks for apartment buildings, with separate ducts per unit or shared runs depending on design. We take precise measurements from the plans and deliver numbered sections ready to hang.

Tightly sealed shop-made ducts reduce dust ingress, and full insulation keeps the interior clean. We use Foster sealant on every seam to stop any air leakage.

Fully insulated and tightly sealed ducts protect against condensation and humidity. We use materials rated for humid coastal environments and seal every seam before delivery.

Once we receive the plans and measurements, we manufacture the ducts and deliver them numbered and ready. Timing depends on project size and complexity; send us the drawings for an exact schedule.