AC duct manufacturing in Al Sarawat

We close the long seams with a tight mechanical lock as the sheet is formed, then seal every seam and every joint between sections with Foster sealant before insulating. Sections leave the workshop with matching flanges that tighten evenly when hung, because any small gap in cold duct means lost air and a point where condensation forms.

Sections arrive fabricated, insulated, sealed and numbered to the route drawing, so the fitters know where each piece goes without cutting or altering on site. What is left on site is joining the sections, fixing them to the hangers and connecting the unit and outlets, which shortens the work above the ceiling.

Yes, we fabricate plenums for both types. A cassette unit plenum is measured to match the unit's outlet frame exactly so air reaches the branch runs without leaking at the connection. A cabinet unit plenum is made to carry both the supply and return paths if the design calls for it. Both types are insulated with Kimmco or Armaflex and sealed with Foster sealant before they leave the workshop.

Yes. The workshop is equipped to fabricate large supply and return trunk runs suited to commercial, government and industrial buildings. Each section is made to the project drawings, numbered and delivered ready to hang after insulation and sealing. When engineering drawings are available, the technical team reviews them before fabrication starts to confirm that the duct dimensions fit the ceiling voids on site.

The duct carries cold air through a ceiling void that may be hot and humid. Without external insulation, water vapour condenses on the cold sheet and drips onto the false ceiling or the goods below. So each section is wrapped in Kimmco or Armaflex in our workshop and every edge and joint is sealed with Foster sealant before delivery.

It depends on the villa's size, number of rooms, and zones to be cooled. We visit the site and measure the exact lengths and diameters before manufacturing, then quote based on those measurements.

Yes, knife-cutting on site leaves gaps and rough edges where cold air escapes and moisture condenses. Manufacturing ducts in the workshop with precise measurement and sealed seams prevents this loss.

Yes, Jeddah's humidity makes insulation essential. We fully insulate all ducts to prevent condensation on cold surfaces and protect the surrounding area.

Coordinate with us in advance about safe access times to attics and storage spaces, and ensure our team can enter and install the ducts without hazard.