Hospital HVAC in Old Airport

Ventilation needs vary from one department to the next based on the activity in each area and the requirements set by the facility's designer and the site survey. Operating theatres need highly filtered, directionally controlled air, while patient rooms, corridors and administrative areas each carry different requirements. We build the duct network and select units from the facility's drawings and its specific requirements, not from general assumptions.

Yes, but it requires careful planning before the maintenance date. We agree with facility management on a schedule that names the section and the right time window, then isolate the target section using dampers and blanking plates without affecting adjacent departments. Corrective tasks such as replacing a capacitor or repairing a flare joint are carried out within the agreed time window.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

Design is governed by the approved facility drawings and each department's requirements as defined by the site survey and the specialist designer. We fabricate ducts in our own workshop from G90 galvanised sheet to project dimensions, and use Kimmco and Armaflex insulation with Foster sealants to control leakage. Distribution and pressure in each section follow the specifications drawn for that department individually.

We work with medical facilities of all sizes, from a clinic in a residential district to a multi-storey medical complex. The size of the facility does not change the principle: the site survey is the starting point, and from it we determine unit types, duct dimensions and fresh-air requirements for each zone. Preventive and corrective maintenance contracts are available for clinics and hospitals alike.

Yes, modern systems in old buildings can face challenges with older ducts and pipes. We understand this mix and service each component for its actual condition, identifying parts that may need replacement later.

Mixed documentation needs careful understanding. We do comprehensive on-site visits, documenting each system component with detailed maps, and send written reports after every service.

Yes, old pipes may be dirty or partially blocked. Duct cleaning improves flow and efficiency noticeably, but we may recommend replacing some pipes if they are in poor condition.

Coastal humidity causes faster corrosion and promotes mould. Routine maintenance includes deeper condenser and duct inspection, dehumidifier cleaning, and protective coating on rust-prone parts.