Mall & retail HVAC in Old Airport

An open door pushes in hot humid air and spikes the heat load suddenly. We include that load in the design and direct a supply outlet above the entrance to form an air barrier that reduces mixing. The survey confirms which arrangement suits each specific doorway.

Yes. A separate unit per tenant means each shop controls its own cooling and a fault in one unit does not affect the neighbour. It also makes consumption readings straightforward and makes maintenance responsibility clear for each party.

A rooftop packaged unit keeps the condenser and evaporator in one casing above the roof, freeing every inch of shop floor from outdoor units and shortening the duct run. Maintenance happens on the roof without entering the shop, which fits scheduling work outside trading hours.

Rooftop units in Jeddah work in hot, salty and dusty air that strains the condenser and speeds fin corrosion. We specify units with corrosion-resistant coatings and include coil cleaning and compressor and condenser checks in the preventive schedule of every maintenance contract.

The site survey decides. A small shop may need only a concealed unit with directional grilles, while a mall requires a duct network with dampers zoned by area. In both cases the positions of lighting, visitor traffic and entry doors are recorded before supply outlets are placed.

Yes, direct sun exposure increases heat load significantly, so we choose above-average capacity and recommend thermal blinds for extra protection.

If you lease multiple units or run a small mall with shared areas, a lightweight central system is more efficient and easier to maintain.

Proximity to the airport may increase humidity and salt exposure, so we use corrosion-resistant units and clean them regularly.

Yes, split units can be relocated and installed elsewhere, but this involves additional costs for dismantling, reinstalling and new connections.