Mall & retail HVAC in Al Faisaliyah

An open door pushes in hot humid air and spikes the heat load suddenly. We include that load in the design and direct a supply outlet above the entrance to form an air barrier that reduces mixing. The survey confirms which arrangement suits each specific doorway.

Yes. A separate unit per tenant means each shop controls its own cooling and a fault in one unit does not affect the neighbour. It also makes consumption readings straightforward and makes maintenance responsibility clear for each party.

A rooftop packaged unit keeps the condenser and evaporator in one casing above the roof, freeing every inch of shop floor from outdoor units and shortening the duct run. Maintenance happens on the roof without entering the shop, which fits scheduling work outside trading hours.

Rooftop units in Jeddah work in hot, salty and dusty air that strains the condenser and speeds fin corrosion. We specify units with corrosion-resistant coatings and include coil cleaning and compressor and condenser checks in the preventive schedule of every maintenance contract.

The site survey decides. A small shop may need only a concealed unit with directional grilles, while a mall requires a duct network with dampers zoned by area. In both cases the positions of lighting, visitor traffic and entry doors are recorded before supply outlets are placed.

We install a central system with sufficient capacity and position the ducts carefully to rebalance quickly when doors open, and assign separate cooling zones to entrances.

We survey the building layout first, then typically run the ducts underground or in the suspended ceiling, or use existing shafts where possible to minimise structural work.

We integrate a dehumidification system with the AC and ensure water drainage from the coils runs safely away from stock rooms and floors.

No, we coordinate with the mall management to schedule maintenance during closing hours or quiet periods, and plan well ahead so trading is not affected.