Mall & retail HVAC in Al Khalidiyah

An open door pushes in hot humid air and spikes the heat load suddenly. We include that load in the design and direct a supply outlet above the entrance to form an air barrier that reduces mixing. The survey confirms which arrangement suits each specific doorway.

Yes. A separate unit per tenant means each shop controls its own cooling and a fault in one unit does not affect the neighbour. It also makes consumption readings straightforward and makes maintenance responsibility clear for each party.

A rooftop packaged unit keeps the condenser and evaporator in one casing above the roof, freeing every inch of shop floor from outdoor units and shortening the duct run. Maintenance happens on the roof without entering the shop, which fits scheduling work outside trading hours.

Rooftop units in Jeddah work in hot, salty and dusty air that strains the condenser and speeds fin corrosion. We specify units with corrosion-resistant coatings and include coil cleaning and compressor and condenser checks in the preventive schedule of every maintenance contract.

The site survey decides. A small shop may need only a concealed unit with directional grilles, while a mall requires a duct network with dampers zoned by area. In both cases the positions of lighting, visitor traffic and entry doors are recorded before supply outlets are placed.

We clean and replace filters monthly or every two months depending on use, ensure the condensate pan drains properly, and inspect the coil for mould regularly.

We size the space and open doors, and usually recommend stepping up capacity or adding a second small unit in severe cases.

Yes, but we need to coordinate in advance to find the nearest parking point and best visit time to avoid congestion.

We inspect the circuit before installing, and if it is weak we recommend a new dedicated circuit by a licensed electrician to ensure safe operation.