Fitted right first time
Split AC installation in Al Yaqoot
In Al Yaqoot, north Jeddah, split AC installation demands precision because most of the modern villas and residential blocks need longer copper runs and proper drainage setup. Alrabih's team positions both units carefully, vacuums the refrigerant line before start-up, so cooling works quietly from day one without condensation dripping.
- Mueller copper
- Full vacuum
- Proper drain
Clients We're Proud to Serve
Organisations and companies that trusted Alrabih with their projects.
When you need a proper installer
- 1
A new unit for a room or flat
You have bought the unit, or are about to, and want it fitted once, not to find a refrigerant leak or water on the floor a few weeks later. Getting it right first time saves you all of that.
- 2
Not sure where the outdoor unit goes
In Jeddah flats the choice is usually the roof, the balcony or the facade. We pick a spot where the condenser gets enough air, a technician can reach it for servicing, and neither noise nor drain water bothers the neighbours.
- 3
A past install that went wrong
Weak cooling since day one, water running down the wall, a loud indoor unit. These are usually installation mistakes, not faults in the unit, and our installation is built step by step to avoid them.
Who it's for
Moving into a new flat that needs AC
We plan every unit position and copper route in one go, so the whole flat ends up neat and consistent.
Ask on WhatsAppFitting AC in a shop or office
We place the units so cool air reaches the entrance and the work area, and arrange outdoor units and drains to suit the shopfront and the building's rules.
Ask on WhatsApp
What the installation covers
- Site check and unit positions
- Insulated copper, sealed wall core
- Drain line with correct fall
- Vacuum and leak test
- Start-up test with you present
How we work
How we work
- 1
Send a photo
WhatsApp us a photo of the room, where the outdoor unit might go and your district, and we tell you what the job needs before the visit.
- 2
Agree positions and route
On site, the technician agrees the unit positions and the copper and drain route with you before drilling any wall.
- 3
Fit and vacuum
We mount both units, run and insulate the copper, then vacuum the line with a pump and check the joints before releasing the refrigerant held in the outdoor unit.
- 4
Start-up and handover
We run the unit, measure the air coming out, check the drain flows, then leave the room clean and show you the remote and how to clean the filter.
A careful install or a rushed one?
| Alrabih | The usual way | |
|---|---|---|
| Vacuum | Pumped before start-up | Often skipped |
| Copper | Mueller, fully insulated | Patchy insulation |
| Drain | Falls, so no drips | Water down the wall |
| Outdoor unit spot | Airy and easy to reach | Wherever it fits |
| Wall opening | Sealed tight | Dust gets through |
Everything your AC needs, from one team
From system design and duct fabrication to installation, commissioning and maintenance.
Split AC installation
Request this serviceDuct installation
Request this serviceCentral AC installation
Request this serviceDuct fabrication
Request this serviceCold room installation
Request this serviceElectro-mechanical works
Request this serviceChiller & AHU installation
Request this serviceHVAC design
Request this serviceAC repair & faults
Request this serviceAC cleaning
Request this serviceRefrigerant charging
Request this serviceCentral AC maintenance
Request this serviceChiller maintenance
Request this serviceAC removal & refitting
Request this serviceDuct cleaning & sanitising
Request this serviceAC servicing by brand
Request this serviceOperation & maintenance contracts
Request this serviceAHU maintenance
Request this serviceFridge & freezer service
Request this serviceCold rooms
Request this serviceDisplay fridges & chillers
Request this serviceFactory HVAC
Request this serviceWarehouse HVAC
Request this serviceVilla & home HVAC
Request this serviceHotel HVAC
Request this serviceSchool HVAC
Request this serviceHospital HVAC
Request this serviceMosque HVAC
Request this serviceMall & retail HVAC
Request this serviceRestaurant & cafe HVAC
Request this service
Some of our work
Ductwork, rooftop units and diffusers, from work we've completed in Jeddah.
Customer reviews
What our customers say
- Muhammadramzan 2641
“MashaaAllah. Services are so good. Behaviour and kindness 100/100. Prices are less then Market. Fully recommended”
- shahzeb armani
“Wow. Prices are so comfortable. Outstanding services. People are so talented and nice”
- Tawfik AlyawerLocal Guide
“U can find all u need for air conditioning”
Your satisfaction matters to us! If you had a great experience with us, we'd love a 5-star rating and a kind review.
Worked with us? Leave a reviewService areas
We come to you anywhere in Jeddah
From Al Shiraa and Al Yaqout in the north to Al Thaghr and Al Quraiyat in the south, with our base in Al Aziziyah.
What sets this district apart
Al Yaqoot is a modern neighbourhood with spacious villas and mid-rise residential blocks that have adequate outdoor space, making it easier to place outdoor units in suitable locations away from damp walls and constant shade. The streets are laid out regularly and access is straightforward, but outdoor space in some smaller villas can be tight, so the copper run and drain path need careful planning to slope correctly and stay out of sight.
Al Yaqoot is in north Jeddah, a neighbourhood of modern villas and residential blocks with open outdoor spaces.
Most installations here need a medium copper run (5 to 10 metres) from indoor to outdoor unit, and outdoor units are typically mounted on north or east-facing walls to avoid direct heat.
The AC setup in Al Yaqoot
- 1
Single or multi-room split in a villa
Most Al Yaqoot villas need one or more splits depending on size and rooms, with the outdoor unit mounted in a separate location away from the front garden.
- 2
Split units in multi-storey residential blocks
Blocks in Al Yaqoot use separate splits per flat, with outdoor units mounted on façades or the roof depending on the building layout.
- 3
Medium copper runs with regular drainage slope
The distance between indoor and outdoor units here is typically medium (5 to 10 metres), allowing a neat copper run and water drainage that slopes at the correct angle.
Before the visit
Before our visit in Al Yaqoot
- 1
Confirm the nearest parking spot and access path
Let us know the nearest parking spot and which path to use to reach the villa or block before the appointment.
- 2
Ensure access to back garden or roof for the outdoor unit
If the outdoor unit will mount on a back garden or roof, make sure gates and pathways are open and safe for the team on installation day.
- 3
Prepare the indoor unit location and check electrical outlets
Decide where the indoor unit will mount on the wall and confirm a nearby safe electrical outlet, and tell us where the main power board is located.
More districts for Split AC installation
Other services in Al Yaqoot
FAQ
Questions about Split AC installation
Will you install a unit I bought elsewhere?
Yes, we install units you have bought yourself. Before the visit we ask the model, its capacity and where both units will go, so we know the copper length. If you have not bought one yet, we are an authorised distributor for Carrier, YORK, General, Midea, Gree and Smart Gold and can help you choose.
Why does the line need vacuuming before start-up?
New pipes hold air and moisture, and Jeddah's humid air adds more. Mixed with refrigerant, they weaken cooling and strain the compressor over time. We pull them out with a vacuum pump, watch that the reading holds so we know the line is tight, and only then release the refrigerant.
Can the outdoor unit be far from the room?
Yes, within the manufacturer's limits for line length and height difference. We use Mueller copper in runs of up to 30 metres without welded joints, so there are fewer joints that could leak, and the survey shows whether a long run needs extra refrigerant.
Can you hide the copper and cables in the wall?
It depends on the house. In a new build or during finishing works, the copper can run inside the wall before plastering. In a lived-in home we use neat plastic trunking in the wall colour. We show you the better option for your home at the survey, before any work starts.
What if the outside wall cannot carry the unit?
We check the wall before fixing anything, because some facades are clad in stone or panels that cannot take the weight. Then we set the unit on a floor stand on the roof or balcony, or on a bracket anchored to the concrete itself, not the cladding, so it does not shake loose.
My villa has a large garden, how do you mount the outdoor unit?
We choose an east or north-facing wall away from shade and damp, and ensure the outdoor unit does not block the garden view or sit near any water source.
Al Yaqoot's streets are wide and parking is easy, but reaching the back garden needs coordination?
Yes, if the outdoor unit sits in a back garden, we ask you to confirm the easiest path and which gate we should use before arriving.
Al Yaqoot gets very hot in summer, does that affect the copper installation?
Yes, we insulate the copper carefully and route it away from sun-exposed surfaces to prevent cooling loss and ensure stable pressure in the line.
Power in the villa might be far from the outdoor unit, what distance can you handle?
The electrical run depends on the unit's capacity, but we typically run the power cable alongside the copper with strong insulation, and we assess this at the first visit.
